Hi guys,I've configured DHCPv6 on a cisco router. DHCPv6 clients get IPv6 addresses which are shown in the " shoow ipv6 dhcp binding". on the workstations I disabled router discovery and enabled managed address as I'm running windows vista and window...
Hi guys,If NAT is configured on a boundary router and is set on the inside and outside interfaces, but show ip nat translations doesn't show any information.Why might the problem be?
Hi guys,If NAT is configured on a boundary router and is set on the inside and outside interfaces, but show ip nat translations doesn't show any information.Why might the problem be?
Hi guys,I'm confused with this command no bgp default ipv4-unicastWhat I understood is, it's used to disable IPv4 BGP. Why would I have to disable it and then configure a router ID.Can anyone explain please.
Hi guys,In a dual stack network, how can we decide whether IPv4 or IPv6 address is used in a simulator software? How to test this?Thank you in advance.
Hi zhenningx,I tried configuring a link-local address on the interface and it pings successfully from the DHCPv6 client workstation.But the problem is this PC then can't communicate with other workstations in the network.I believe I need to configure...
Hi guys,Here is an inserted image of the topology.and here are the two used configurations. Sample configuration 1:ip nat inside source list 100 interface Serial0/0/1 overload no access-list 100 permit ip 10.0.0.48 0.0.0.3 any ======================S...
Hi stmillet,Thank you for replying.I used the no form of that command.I get an IPv6 address on a workstation, and it's the own shown in the show ipv6 dhcp binding but still I can't ping the gateway.Is this a limitation of DHCPv6 or I have a problem ...
