Hello,  Is there any configuration document which explains about MPLS hub and spoke without any tunnel? The requirement is to avoid spoke to spoke communication directly and all traffic from spoke 1 to spoke 2 should be through the hub site, even tho...

What is the command to find out the backup path for a route in OSPF when the primary path is active. The show ip route is diplaying only the active path and the show ip ospf database is also showing the advertised-router which is active at the other ...

Hello,  Is the below a valid commuity configuration?ip community-list 100 permit ASN:100Route map Com-list permit 10 (Applied In bound)match community 100Since there is no action that was specified on the match statement. If this is valid statement c...

Hello,  I am confused with the route tagging between routing protocols. When i was going through different documents, i am not able to understand the tagging information. The configuration shows some tag number when redistributing between the routing...