i have one access switch (2960)which is connected to core switch(4506)and trunk is enabled on both the switches for connected ports, if i will remove the trunk command from my access switch and i'll put access switch connected port on core switch in...
i have two cisco4506, Active and Pasive i have done vlan based HSRP on it, also i have one gateway router connected to MPLS cloud, how do i connect that single router to both the switches? with single gateway ip for both the switches
What you can do is, just check the gateway of that 192.168.1.0 clients it should be 192.168.1.22 if that clients have different gateway address (another router) then that router should have route back to the ASA for your 192.168.10.0 network.for an ...