About bjorn.stenborg

bjorn.stenborg · 03-21-2007

Hi!We have a problem when enabling mode configuration. ESP tunnel setup works fine without, but when we enable mode configuration in the client, our Cisco router doesn't accept the IKE phase 2 proposal.The error seems to be "no IPSEC cryptomap exists...

bjorn.stenborg · 03-23-2007

I'm afraid that didn't help either. We have an idea that the root of the problem is that the client receives a new IP address through mode config, but then it doesn't use this address in the phase 2 proposal so the gateway can't match the proposal to...

bjorn.stenborg · 03-21-2007

Hi Gilbert.Thank you for the suggestion. Unfortunately, adding the local-address changed nothing. If I understand correctly, this command is for when you have the same crypto map associated with multiple interfaces, but we do not in this case. We do ...

bjorn.stenborg · 03-21-2007

Here are two logs with and without mode config enabled in the client. Same router configuration in both cases.

Member Since	‎03-21-2007 03:30 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	4

User Statistics

User Activity

IKE phase 2 failure when using mode configuration

Re: IKE phase 2 failure when using mode configuration

Re: IKE phase 2 failure when using mode configuration

Re: IKE phase 2 failure when using mode configuration