I have problem with CM update when send a new package to SCE.SCABB return the follow message: Updating CM <CM IP Address> with service configuration timed out. Operation proceed in the backgroung.How I could resolve this problem?
I have one 7600 connected directly in the switch Force10 model E300 configured in this fashion:Router 7600interface GigabitEthernet5/2 description <ommited> switchport switchport access vlan 46 switchport mode access no ip address load-interval ...
I have the situation described in the attached diagram.All packets originated in the server 10.x.x.1 are translated to outside serial IP address.So, if any user in the internet want to get access to that server, they reach it by outside serial IP add...
ThanksBut I don't use only TCP port 80, I have large port list and this type of configuration is not desirable.Is this possible to make it with another config type?
Hi,I didn't try this test because I don't have authorization to execute it.We have many services in these devices and I can't configure a route to these Multilink interfaces.
