I am having Cisco 892 router which has two ISP(MPLS), and i configured auto failover between two ISP. Also configured a Load sharing between two ISP. Configuration attached for reference Auto fail over is working fine but In load sharing Intranet sit...

Recently we have bought 4 no. of Cisco ISR 4321 / K9 Router. Firmware which are loaded is 03.16.04b.S   Let us know is there any impact on this       Thanks in Advance Asif    

My router Interface (Gig 0) Won't come up after applying 'no shut' command. Interface continue in down status GigabitEthernet8           10.0.0.226      YES NVRAM  down                  down Thanks in Advance Asif

I have configured a Two service provider BGP configuration in single router. Configuration as given as below... G_Ware#sh running-config | s routerouter bgp 64515 no synchronization bgp log-neighbor-changes network 10.103.0.0 mask 255.255.240.0 neig...

How to bind Single LAN IP with particular MAC address on cisco router and same is allowed by router. Thanks in advance Asif