Hi, I am trying to achieve multicast over our MPLS network. We use a GRE tunnels between our sites to establish an internal MPLS core. Using BGP we are able to route our enterprise VRFs between the sites. One of our VRFs requires bi-directional multi...
Hi,
Am having some issues getting a route map and NAT working. I have 2 LAN's and a /27 block of public IP address. I need one LAN to use just one of the public IP address and the other LAN to use one of the public IP Address out of the assigned pool...
Hi All, I have a network that has 2 ISP connection, ISP1 and ISP2. I require any data on VLAN10 to NAT Overload to ISP1 which is simple and is working fine. I now also require data on VLAN30 to dynamic NAT to a pool of public IP address on ISP2 and V...
@Giuseppe Larosa I took the fVRF off the tunnel just to see if that made any difference. I also decided to reboot the devices after I made the changes. Did a ip pim vrf A nei and I have a PIM neighbor. I reapplied the fVRF and did another reboot, di...
Hi @Giuseppe Larosa MPLS auto configure is enabled on the OSPF instance, my understanding is that this negates the need to add the MPLS IP command on the tunnel interfaces? The tunnels are in the global routing instance. Using a fVRF as the tunnel s...
Hi,Below is the config for router one for each site. *** SITE 1 ****hostname site01-rt01!vrf definition Ard 65010:1route-target export 65010:1route-target import 65010:1route-target import 65020:1!address-family ipv4mdt default 239.1.1.1mdt data 239....
