About connect2world

connect2world · 08-10-2011

Hi Folks,I have a strange problem here, hope some one can shed some light to resolve it.Network Setup===========2 Site to Site VPN tunnels has been established, it is a hub and spoke topology. The hub is ASA5520 and the 2 spoke are a 1841 and 1801 ro...

connect2world · 08-19-2009

Hi Folks,Scenario:The company are migrating each region network into a MPLS cloud. Each region has their own subnets to take care and they manage their own internet gateway. The internet access for each region is serve by the region office internet g...

connect2world · 12-23-2008

Hi Guys,Can the below setup work?WS-C2960-48TT-L (Gigabit uplink) ---- Cat 5 Lan cable --- Media converter 10/100 --- Multimode fiber < 50 meters ---- GLC-SX-MM= --- CE500G-12TCPlease advise, thanks.

connect2world · 12-14-2008

Hi Folks,I have a couple of ios routers 1841 series as the spokes and a central hub using a ASA5520 box. The Lan to Lan VPN has no problem communicating with sub nets behind the ASA box to the spokes A & spoke B.Problem occurs with inter spoke commun...

connect2world · 12-08-2008

Hi Guys,I am faced with the challenge of connecting 2 switches located at different building next to each other. I choose to have on one end, the core switch WS-C3750G-24PS-S with transceiver module GLC-LH-SM plugged in, single mode fiber cable runni...

connect2world · 06-12-2012

Hi Hari,I am assuming that the network for 182.93.93.98/32 is connected directly to the router hosting 10.168.202.4/24 network? If that is the case remove the advertisement on R1 for network 182.93.93.98 mask 255.255.255.255And also remove the static...

connect2world · 08-21-2011

Hi Javier,If you notice my config , that statement has already been added.

connect2world · 07-25-2011

Hi Did you include allowing all the ipsec port your access-list IP-ACCESS-IN? Similar to the below:10 permit udp host source_peer_ip host destination_peer_ip eq isakmp 20 permit udp host source_peer_ip host destination_peer_ip eq non500-isakmp30 per...

connect2world · 07-24-2011

Hi,I believe your config statement has left out the some important ip-access list rule.Add these statements on top of the access-list 102(subsitute the destination_peer_ip with your actual peer IP.):access-list 102 deny udp host any host destinatio...

connect2world · 12-12-2010

Do take a look at this document : https://supportforums.cisco.com/docs/DOC-8313 , it should take care of both your requirements.

Member Since	‎12-05-2005 06:00 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	56
Total Helpful Votes Received	9

User Statistics

User Activity

Random L2L IPSEC VPN disconnect

How to advertise default gateway to only certain subnets in BGP

Fiber link between 2 office with media converter

Site to site VPN between spoke ios routers with an asa as hub possible?

Fiber link between 2 buildings

redistributing bgp into ospf

Random L2L IPSEC VPN disconnect

Point to Point IPSEC, NAT-T, and PSK failing phase 2

Re: How to keep a VPN tunnel open?

Re: Route specific subnets to ISP 1 with dual ISP connections