About Niels van der Made

Niels van der Made · 03-06-2017

Hi all, I'm currently evaluating Cisco Prime Infrastructure and I ran in some strange issue.When I add one of our wlc's I do see wireless clients and all kinds of info from the wlc but it can't see the actual access points.(See the attached screendum...

Niels van der Made · 12-04-2014

Hi All,Since a couple days I'm experiencing an issue with a C819-4G router.The 4G connection unexpectedly disconnected, and I am unable to get it connected again.There have been no configuration changes, and this config works fine in a spare router.I...

Niels van der Made · 06-15-2012

Hi all,I'm configuring a l2l tunnel.While configuring the crypo acl I noticed that my ASA was accepting subnetmasks like 255.255.255.1 (wich does not exist to my knowledge).I then tried some other masks, and to my surprise it accepted almost everytin...

Niels van der Made · 05-08-2012

Hi all,Over the last couple days I've been experimenting with the new NAT config with version 8.4(2), and I've got a couple questions.For example:My production ASA is running on version 8.2(3) and has the following config:global (outside) 1 interface...

Niels van der Made · 05-25-2011

Hi all,Yesterday i ran into a strange problem.I installed a Cisco 881 router behind a 2960 switch.On both devices i configured 100mb full duplexing, so auto neg off.Also i configured an IP on the interface.So the interface now looks like this:Router#...

Niels van der Made · 05-04-2017

Probably hardware failure, we've replaced the router at the time. Since then it's running fine again.

Niels van der Made · 03-08-2017

Sorry pushed the answer button unintended... 1) ncs status (from an admin ssh logon) Warning : Unknown hardware type : KVMHealth Monitor Server is running. ( [Role] Primary [State] HA not Configured )Database server is runningFtp Server is running...

Niels van der Made · 03-07-2017

No, somehow PI doesn't recognise any access point from any controller.On a previous instance of PI I did not have this problem, so I'm beginning to think there has gone something wrong with the installation.

Niels van der Made · 08-13-2015

Based on the TCP FIN, it looks like the tcp handshake is not completed, but based on the logging I can't see why.If you do a telnet outlook.office365.com 993 from te client, do you get a connection then?Also what kind of error message are you getting...

Niels van der Made · 08-13-2015

%ASA-6-302013: Built outbound TCP connection 21356473 for outside:132.245.63.226/25 Looks like the connection is made to port 25 instead of 993, looks like an application issue.Make sure the mailclient has port 993 configured, probably a "override de...

Member Since	‎02-05-2010 04:55 AM
Date Last Visited	‎09-28-2017 07:46 AM
Posts	24

User Statistics

User Activity

PI3 Access points not pulled from wlc

C819 4G modem not recognized

ASA accepts non existing subnetmask in ACL

PAT ASA 8.2 vs 8.4

Duplexing bug 881 router

Probably hardware failure, we

Sorry pushed the answer

No, somehow PI doesn't

Based on the TCP FIN, it

%ASA-6-302013: Built outbound