About soumik.mondal

soumik.mondal · 09-16-2011

Dear AllAs per our management policy we have to migrate our data centre to IPV6.Right now each device is running on IPV4.We have catalyst 2960 which I want to configure in dual stack.Now from Cisco site I found that first I have to change SDM into du...

soumik.mondal · 05-23-2011

Dear AllWe have two internet connections for our DC .45 MBPS- GigabitEthernet0/2 ---------------- ISP -A IP ADDRESS 100.236.65.2532 MBPS-GigabitEthernet0/3----------------------ISP-B IP ADDRESS 202.138.226.253DNS- of ISP-A 100.236.167.130We u...

soumik.mondal · 04-01-2012

A loop is generated towards site B.It is not from your Site A or Site B modem, because both end serial is up.Co-ordinate with your service provider regarding the loop.I think a loop is generated from service provider end only .Please reply after doin...

soumik.mondal · 06-21-2011

Dear all .The previous problem of fail -over is sorted out.Thanks to all for the responces .Now I have another requirement .My management wants the aggregation of the ISP A and ISP B.If I go for multilink, I want to know that the perfomance or flappi...

soumik.mondal · 05-28-2011

Dear allThe problem solved after I add the route Router(conf)#ip route 100.236.167.130 255.255.255.255 100.236.65.254But This is not working Track 1 ip sla 1 reachabilitydefault-state updelay down 60 up 60Thanks & RegardsSoumik

soumik.mondal · 05-23-2011

Thanks for your reply.I can not test till the week end .

Member Since	‎05-23-2011 05:48 AM
Date Last Visited	‎10-09-2017 01:49 PM
Posts	6

User Statistics

User Activity

SDM for IPV6

IP SLA HELP

Serial interface - leased line connection

Re: IP SLA HELP

Re: IP SLA HELP

Re: IP SLA HELP