When a WAE in the Data Center receives a SYN packet that is marked with the TCP Option 0x21, it knows there is another WAE on the Branch side and marks the returning SYN_ACK with the same TCP option. This is auto-discovery in a nutshell.The WAE's ar...
I have seen similar issues when using the sys image for 4.1.x, but I have always found it better to reimage the WAE appliances with the recovery CD where ever possible.If you are able to do that I would definitely advise using the CD over the sys ima...
Case 1------ 1 - You are correct, by default the load balancing is done using source ip. You can configure the WCCP load balancing based on the hashing algorithm used, either hash assignment or mask assignment. Hash assigns each WAE a specific numb...
The configuration that you have above only sets the bandwidth to 100Mbps, the default setting that would come from the CM would still be half duplex. See under "WAE - Configure - Interception - Inline - Inline Interfaces"The correct setting for this...
