About Predrag Jovic

Predrag Jovic · 07-28-2018

Most likely recursive loop is created since you are advertising tunnel endpoints through tunnel. Route to tunnel endpoint should not point to tunnel (need to point to wan interface). Can be achieved by filtering tunnel endpoints with distribution lis...

Predrag Jovic · 07-27-2018

If manually configured router-id under ospf router will use that ID to identify itself to other routers while advertising ospf routes. Only if router-id is not configured router will need to go through router id selection to choose which IP address i...

Predrag Jovic · 07-27-2018

By default EIGRP default route is marked as external D EX with AD 170, while OSPF has AD 110 for all route types which I would guess is root cause of your issue. You can try to change EIGRP external routes AD to 105 to keep preferring EIGRP default...

Predrag Jovic · 07-27-2018

Can you, please, check routing table and interface status. show ip interface brief show ip route If routing table is present and interfaces are in up up state my guess would be that issue may be: - cable swap between Gi0/0 and Gi0/1 - port configura...

Predrag Jovic · 07-18-2018

Commands that are given supposed to be issued under interface (config-if). According to output commands are issued under global configuration mode (config).

Member Since	‎07-09-2015 10:48 PM
Date Last Visited	‎03-19-2020 02:35 AM
Posts	200
Total Helpful Votes Received	188

User Statistics

User Activity

Re: EIGRP via GRE tunnel taking preference

Re: router-id 1.1.1.1 ---->>>I dont have interface with address 1.1.1.1 , but i see it works

Re: OSPF Totally NSSA default route selction process

Re: Strang Router Behavior

Re: Switch Config Template