Dear All,
Have fun with Cisco,
I'm facing some problem in mobility. Here is my scenario, I have four AP in a floor which is cover hole floor. But when I am moving from one AP to another AP, users couldn't shift in nearest which AP. But when I disconn...
Dear All Friends,
I;m facing some problem configuring my ASA 5516-X. I have configured LAN and DMZ Zone. Both network going to internet as usually but when I'm trying to go DMZ to LAN it is working fine but when I am trying to go LAN to DMZ it is not...
Dear all specialist,
Good day at all,
I want to design my wireless network where WLC located in central office. All AP from branch and central office connected to WLC via data network. So what process should I follow for this solution.
Regards
MEHED...
Dear All genius,
I want to connect my 5 branches via 5 different ISP. All internet permission will be via HQ router. And also has data connectivity with each branches to HQ.
What protocols should use for this types of network.
//Mehedi
Dear All,
I have created a Guest network which is authenticate by Web portal. We have also created users for this portal. Normally users connected as usual.
Now problem is when user disconnect from SSID and reconnect to that SSID it don't required us...
Thanks Sandeep,
Here for your information, Where I have configured my WLC in the same site. Also another vedor controller in the same site. It is working fine. Like One network goes to WLC network and another is in other vendor controller.
So this i...
Thanks Dan,
I am using VXR7200 series router IOS version 15. My problem is how can i pass nat and data network at a time. I guess first need to up GRE tunnel with all branches to HQ then permit nat for this ? If i use different NAT router & tunnel ro...
Thanks Scott for your valuable comment. I setup it in a very simple way only one network and one SSID running on this network and all AP in local mode. Here is Show WLAN 1 configuration:
WLAN Identifier.................................. 1Profile Name...
