Hello,I have Firepower 2013 and i need to reconfigure, i don`t have the console password and i need to know how i can break it.

Hi, I have a 4 FTD FW ( 2 FP2130 & 2 FP 2110 ) managed by FMC v 6.5.0 I  have 4 critical health monitor notification ( threat data updates on devices cisco cloud configuration - failure ) at each FWI don`t know what the meaning of this notification a...

Hi Guys , i have cisco catalyst switch 3560 and have a SG350-28 switch want to link them togetherbut, i have a question at 3560 the stp type is PVST & at SG350-28 i can`t configure PVST it`s not option i have until RSTPSo, if i connect these 2 switch...

Hi GuysI am a beginner at FTD and i have a basic question about how to make logging to any rulei just want to show the log of traffic to know if the traffic pass through this rule or noti searched about it . but i can`t find a simple steps after crea...

Hi guys I have 2 ASA firewalls active/standby version 9.8(2) by ASDM I change the security level of the interface from 100 to 0then I found this message in below photo I didn`t read the message I want to finish this task quickly  so I press on "force...