About giorgos78

giorgos78 · 06-19-2012

Hi allI was assigned a task to configure an SG300-28P to have 3 different vlans.VLAN1 192.168.0.0VLAN2 192.168.1.0VLAN3 192.168.2.0Now on VLAN1 their will be only one device configured with static IP 192.168.0.230On the other 2 VLANS there will be a ...

giorgos78 · 09-18-2011

Hi allI have 2 questions to ask pls1. I want to be able to connect any IP Phone or softphone to a UC540 via internet connection. We want to avoid VPN for making things easier for teleworkers and for us as IT also. I have been trying for hours to get ...

giorgos78 · 06-12-2011

Hi allI 've been trying for 3 hours now to connect a SPA525G2 on a UC540. I have some 504 IP phones which i managed to connect fine but this one does not want to register itself with the UC540.I have tried everything mentioned on this link http://uc5...

giorgos78 · 05-29-2011

HiI have setup a UC540 for SIP voice. Unfortunately i haven't been able to make it workCan anybody propose me any hints to check for by reviewing the attached debug log output?Thanks

giorgos78 · 04-20-2011

Hi allWe have the below challenge:A company is providing corparate services for companies abroad. They want to provide also telephone services. They have purchased a cisco 7962 IP Phone along with 2 X 24 7915 expansion modules. This phone is going...

giorgos78 · 06-19-2012

The problem is that i dont know how to do that with this switch as everything is GUI and there is no IOS CLI to work on.I am trying to switch it to Layer3 mode and see how it goes.Thanks

giorgos78 · 06-19-2012

Hello VijayActually i have just reset everything to the default settings. Lets forget at the moment the connection between VLAN2 and VLAN3. What matters most is that both vlans should see VLAN1. Now as i said keep in mind that on VLAN2 there is one s...

giorgos78 · 06-13-2011

Updated UC540 IOS through CCA and everything worked fineThanks

giorgos78 · 06-12-2011

I have done this many times before and after the firmware upgrade but still no luck.Any other options?Thanks

giorgos78 · 05-31-2011

Well we brought in a VOIP expert to fix our problem.He removed ip outside nat from vlan2 and created a new simple translation-rule 12345678 678 and a new dial peer for incoming calls 1234567. and everything worked like a charm However i must say a ve...

Member Since	‎10-17-2009 08:19 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	14

User Statistics

User Activity

SG300 multiple vlans with multiple routers to talk to one IP Address

Registering SIP and SCCP phones through the internet

SPA525G2 uc540

Unable to make calls

Provide telephone services for companies

SG300 multiple vlans with multiple routers to talk to one IP Add

SG300 multiple vlans with multiple routers to talk to one IP Add

Re: SPA525G2 uc540

Re: SPA525G2 uc540

Re: Unable to make calls