Hi all,
We have deployed VSS couple of weeks ago on 4506-E with SUP7L-E Supervisory Engines,
As VSS works fine, we want to go ahead and implement MultiChassis EtherChannel, that’s where we are faced with a bit of a problem on a performance side;
...
I'm having a problem configuring Remote Access VPN (SSL, Anyconnect ect.) on ASA Service Module on 6509-E. Is this even supported or am i wasting my time trying to make something work which will not work in a first place :) ? Site-to-Site works with...
Hi allHaving a problem bringing up 10GB ports between two Cisco 6509-E VS-SUP2T-10GB , they simply are not comming up Physically.Model: 6509-ESUP's: Factory ID: VS-S2T-10GB-XLUsing IOS Image: s2t54-adventerprisek9-mz.SPA.151-2.SY.binTransceiver: X2-1...
Hello Please I need you assistance, I have 2 routers router A and Router B connected with Ethernet to each other, and each router has its own E1 for data traffic. What I want to do is, when E1 on router A is fully loaded I want to send the traffic to...
HelloPlease I need you assistance, I have 2 routersrouter A and Router B connected with Ethernet to each other, and each router has its own E1 for data traffic. What I want to do is, when E1 on router A is fully loaded I want to send the traffic to r...
Yes Marvin i am running in multiple context mode, so I'm done with SSL unless i convert back in Singe mode i guess.Just to confirm will the Remote Access VPN be available if i convert back to a single routed mode ?Thanks
SolvedGlad to inform that the problem was Transiever, all 4 of them !!!, higly unlikely situation but it happened.I have got the same model of Transievers and used them interfaces came up just fine.Will ship those transievers back and get a replaceme...
Hi When connected interface status are as follows:SW-1Router#sh int t5/4TenGigabitEthernet5/4 is down, line protocol is down (notconnect)SW-2Router#sh int t5/4TenGigabitEthernet5/4 is down, line protocol is down (notconnect)Router#sh int status modul...
HiI already have EIGRP running on both routers , yes you can load balance traffic, this i can do, but i want to load balance after the first E1 is full and only them redirect traffic to another.
