I am trying to create a wireless bridge with 2 1200 AP.The "Client" is giving me this error message:Interface Dot11Radio0, cannot associate: No matching privacy setting (from 001b.d5c8.ce80)This is the master config:version 12.3no service padservice ...
Is there a limit to the number of patch cable I can use between 2 100 FX switches ?I know that every time you add a connector you loose some of the signal strength. Is 600 feet and 6 patch too much ?
I am in a shop environment.If i install a copper cable with shielding do I need to have it connected at both end ? I am wearing that I could have ground problems with a long run of cable. What if my 2 grounds on the switches are different can I dama...
We are building a new shop and I need to install AP to cover the whole building. I am planing to install the new Aironet 1250 with the 2.4 Ghz 3Dbi triple omni antenna. How do you calculate the size of cell I need ? If the building is a 425 feet squa...
I have 3 routers A, B and CAll 3 routers are connected by vlan 2 This is there address on vlan 2:A 172.17.4.31B 172.17.4.33C 172.17.4.63B and C have vlan6 and are configured with HSRPB 10.30.30.33C 10.30.30.63HSRP 10.30.30.70 (C is active)Router A is...
Oups! the building is a square 425 x 425 feet180625 square feet. Sorry English is not my first language. I did not yet decide the freq I was under the impression that n was on 2.4Ghz.What would you use to a site survey ?
What do you do when there no site to survey ? I need to budget a wireless solution for a new building. With all the numbers and the radiation pasterns in the antenna spec there must be a way to calculate the theoretical range of the antenna.
