HelloI appreciate and thanks in advance if you can help with this simple configurationIn SG300, in layer 3 mode, how can you make 2 VLANs see each other?In my home lab:VLAN1 default (GE1: Access mode) 192,168,2.254VLAN10 Stati...
HelloI just upgrade my SG300 to the latest firrmware 1.3.7.1.8 and I have encountered this issue:- By default, the VLAN interface was Enabled but the display is always Disabled- I can not change it and I cannot ping the VLAN IP interface as well (I...
Hi Marty, TomsThanks! Thanks! Thanks! It works so I am happy.Thank you for sending the link to the Guidance Document.I finally makes it work with Pfsense firewall router. My VLAN10 can see the internetThe find out The term Multiple Subnet on One Pbys...
Hi MartyI have another questionHow can this step be done on the router whaout creating a VLAN interface?He already have 192.168.2.1 in the previous step. He is now creating 192.168.3.1. So there must be an Interface for this network. But this is his ...
Hi Tom, MartyI follow closely the guidance and still stuck at the single issue My VLAN10 still stuck inside and cannot see the internetHere is the summray:Port GE25 connects directly to 192.168.2.1. Trunk, untaggedVLAN1: Port 1-22 Access Mode, unta...
Hi Marty, Hi TomI run into the following situation:1- When I add VLAN10 interface, the switch add automatically IPV4 Route and make it uneditable, with no next IP, and does not allow Internet access to VLAN102- When I delete VLAN Interface, the switc...
