About freeness4

freeness4 · 07-18-2015

Using dual wan, I am trying to get 2 PCs to only use WAN 1 for all traffic. I've tried bandwidth management and protocol management, but about half of the time I go to whatismyip.com it shows me the IP of WAN 2.Bandwidth management, using rate contr...

freeness4 · 07-18-2015

Using dual wan, I am trying to get 2 PCs to only use WAN 1 for all traffic. I've tried bandwidth management and protocol management, but about half of the time I go to whatismyip.com it shows me the IP of WAN 2.Bandwidth management, using rate contr...

freeness4 · 07-20-2015

I want to use load balancing, not smart link back up. I figured it out. In protocol management, I had all ports for 192.168.0.0 to .199 set for WAN 2, but that cause total failure for all those IPs. I set it to 192.168.0.100 to 199 and that worked...

Member Since	‎07-18-2015 04:22 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	3

User Statistics

User Activity

Getting a specific PC to only use WAN 1 on an RV082 with Dual Wan set up

RV082

I want to use load balancing,