About sarathpa

sarathpa · 08-31-2016

Can i get an explanation for the below message "flush request sent". 28) Event:(null), length:159, at 352708 usecs after Thu Dec 11 02:31:06 2014 stp_flush_vlans_multi_port(2671): # of flush requests sent: (a) this batch: 1, (b) total: 3515; # of po...

sarathpa · 12-21-2016

Hi, It is expected behaviour, when you remove the VLAN from L2 database with "No Vlan xx" command and you have SVI interface for the same VLAN will remain in running config. You need to remove manually using below command. Also you can see the output...

sarathpa · 10-18-2016

Hi, You can run any dynamic routing protocol between VLAN 10 SVI and MPLS router to advertise VLAN 11 subnet. Or you can do the static or dynamic NAT or NAT-PAT to convert the source IP address

sarathpa · 09-28-2016

Hi, May i know where the router is connected to. Do you have access to that device. Also we need to the router interface ip address which is connecting to internet.

sarathpa · 09-21-2016

Hi, By default, all cisco catalyst enabled with STP. When you connect 2 or more switches in loop. It will automatically detect the loop and will take one port to blocking state. If you are seeing the loop. Then please share us the "show spanning-tr...

sarathpa · 09-19-2016

Hi, Could you please check "show ip int brief". I believe your protocol should be "down" since you configured two different subnet ip address for directly connected interface.

Member Since	‎07-18-2015 05:52 PM
Date Last Visited	‎08-08-2018 12:02 AM
Posts	25
Total Helpful Votes Received	10

User Statistics

User Activity

Flush request sent

Hi,

Hi,

Hi,

Hi,

Hi,