Hi, i found some documents to readhttp://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/san_switching/b_Cisco_Nexus_5000_Series_NX-OS_SAN_Switching_Configuration_Guide/configuring_and_managing_zones.html"All other switches in the fabr...
Hi, morteza badizamani.I think the main reason is default maximum path option of 4( max is 16) in OSPF ( you can check this by show ip protocols) thats why you see only 4 next hop per destination network. If you have more than 4 next-hops for destian...
Hi Osbin, Why the white paper below states that if FI are connected to both MDS, then it will create a single point of failure?FC protocol build a fabric, using FSPF protocol (like OSPF) so MDS`s, FI (switching mode) Nexus 5k, 7k (storage VDC) form a...
Hi Craig.when you configure ZBF there are few rules:security zone = interface/ interfaces.Data between two created security zones is droped by default So you should add interfaces in zones, create zone-pairs (which have direction) and assign a policy...
Hello Svetoslav.In a default mode asa 5505 is a L3 switch, so you do not need any routers between asa and servers.Asa (every model, including 5505) support routing, nat, and many additional technologys.Also you may use router if you want to. In yhis ...
