What is the WLC OID to collect the throughput per AP radio? I have been digging through the MIB tree for my WLC AIR-CT2504-5-K9 but haven't found it. The WLC Monitoring Dashboard shows this, but I need to collect it over SNMP.
I have a lightweight access point AIR-CAP3602I-A-K9 with an AIR-RM3000AC-A-K9 ac radio module installed. The AP has a couple of built-in radios, one for 2.4 GHz and the other for 5 GHz that supports WiFi n at most. All works fine except that it appea...
Hello. I'd appreciate any assistance solving the following problem. This is a basic layout of the network:EDIT: I'm working with real devices, not on Packet Tracer. Wireless clients on VLAN 200 obtain IPs from a DHCP server on VLAN 1 through a route...
According to this table the ISR 1900 series supports EHWIC, HWIC, WIC, or VWIC cards. As far as I have found none of these are routed interfaces, but layer 3 switch interfaces. Does the ISR 1941 support cards with routed interfaces?
Hello everyone.The image below is a simplified layout of my home network where I have a web server with port forwarding. From the WAN the server is accessible, and from the LAN it is through its LAN IP, as expected. The question is, how to make the s...
Thanks! Found it under cLApDot11RadioRateStatsEntry. cLApDot11RadioRateStatsRxBytes and cLApDot11RadioRateStatsTxBytes have the bytes received and sent for each radio per data rate per AP.
Doing further digging I found Cisco Wireless Controller Configuration Guide, Release 8.5, which says that "The 802.11ac radio in slot 2 is a subordinate radio [...]. Because the 802.11ac is a subordinate radio, it inherits many properties from the ma...
Hello Rich. You are right, it only gets to 80 MHz. The GUI letting me select 160 MHz misled me.The WLC is an AIR-CT2504-5-K9 V03 with software v8.5.164.0. Under Wireless > Access Points > Radios > 802.11a/n/ac I can set the channel for the internal r...
Solved!After the above, I had a hunch that this was some kind of interoperational bug between ZBFW and DHCP relay. Then I found DHCP Client or Server with ZBF Router Configuration, which prompts to pass DHCP requests and replies from and to the route...
