Hi,
Have the latest HUU 2.0(10b) and have tried the following ways to update the firware, with no success:
a) KVM mapped DVD - too slow
b) USB Boot - displays message that firmware cannot be copied.
USB boot is the preferred method as it just fast...
Hi, I have a Cisco C220 M3 server with a VIC 1225 card installed which is running ESXi 5.5. We have a pair of 7k's with a vpc peer link. The 10gb ports on the server are split between the N7k's. A management vswitch is configured, with both nics ...
Hi, I hope someone can helpWe have 2 separate UCS installations, identical hardware config; 2, FI's, NetApp direct-attached storage, and upstream HP switches. I have one installation up and running, iSCSI boot working fine.The other ins...
HelloI am trying to remove an uplink from an IOM to the fabric interconnect as its not required. I have tried to reset the I/O module and re-acknowledge the chassis with no luck, it is still shown in the GUI with the error message as in the subject....
Hi Karthic
I used Rufus to start off with, then moved to unetbootin, both had the same issue.
HUU starts fine, and then displays 'copying firmware and tools' (i think), and then a dialogue box appears stating that the firmware could not be copied. ...
Thanks Wes, however using HUU was my original issue. Using KVM-mapped DVD was way too slow (after 40 minutes, it was still loading and I never left it long enough to carry on), and via USB boot it displayed a message stating the firmware couldn't be...
Hi Amit, below is the config from the n7k. I have also attached the networking config from the ESXi host. interface port-channel 19 description *** EXSi server *** switchport switchport mode trunk switchport trunk allowed vlan 8,9 spanning-tree...
I came back to site this morning, booted a blade and got the Option ROM sucessfully installed message, having made no config changes. I booted the vmware installer, however it still could not see the LUN. I could see the session on the netapp though...
