About hkupper

hkupper · 06-27-2012

Hello,we have over 100 AP1242 with c1240-k9w8-mx.124-23c.JA2 image, tow 5508 controller and WCS running. After the ap reboots, the duplex settings of the fa0 interface change to half duplex. I have to set it manually to full duplex. In my WCS or with...

hkupper · 02-20-2012

Hi,LMS 4.0 shows "could not detect SSH protocols running on the device. Failed to fetch config using SCP.Connection timed out: connect Verify SCP is enabled or not."SSH and SCP are enabled on all of our switches. On some switches it works on other no...

ssh ignore privileg level of user · 02-15-2012

Hi,on my c2960s-24-TS-L switch I have configured aaa, ssh and a user with privilege 15. When I open a ssh connection to the switch and login as the privileged user, I am not in the enable mode. On my 2960G switches it still functioning.Best regards,H...

hkupper · 12-15-2011

Hi all,I have setup an oeap 600 and it joins the primary controller 5508. The corporate SSIDs are showed in the wlan client but the client cannot connect to the SSID.The event_log from the oeap shows:*Dec 15 16:14:30.807: ADD_MOBILE from WLC,wmeEnabl...

hkupper · 09-02-2011

Hi,LMS 4.0.1 istalled. If a device fault occours and I click on the error then the DFM shows "sorry, an error occoured".Any ideas?Regards, Hubert

hkupper · 06-27-2012

Ok. My APs were in auto mode for duplex and speed originally. Speed works fine but duplex not. So I will try the configure ap ethernet duplex speed for my APs and I hope this will help.Many thanks and best regards,Hubert

hkupper · 06-27-2012

Sorry, I always plug the AP to the switch but an reboot from the switch or AP set the AP in half duplex mode. Then I have to set full duplex manually for the time to next reboot.RegardsHubert

hkupper · 06-27-2012

Hi,I always use a ssh session to the AP to set the "duplex full" command to the fa0 interface. What is the differece to telnet over the WCS?Best regards,Hubert

hkupper · 02-28-2012

Ok, it seems I sovled it.I deleted the failed devices from DCR and then added them manually. Now LMS fetches the configs correctly.Cheers,Hubert

hkupper · 02-26-2012

Please post in english. I don't understand france.

Member Since	‎01-18-2011 02:16 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	36

User Statistics

User Activity

AP 1242 change duplex settings after reboot

LMS 4.0 ans SSH/SCP fails on some switches

ssh ignore privileg level of user

oeap 600 can't connect to corporate SSIDs

LMS 4.0 DFM error

AP 1242 change duplex settings after reboot

AP 1242 change duplex settings after reboot

AP 1242 change duplex settings after reboot

LMS 4.0 ans SSH/SCP fails on some switches

Re: LMS 4.0 installation stucks