I am experiencing slow internet connection. This week I upgraded my connection to 50/10 but when I run speedtest I am only getting 10/5 (which was my old speed).   These are some of the commands I've run:   sh int e0/0  Interface Ethernet0/0 "", is u...

I might not have chosen the correct community, but anyway: I have four static ip-addresses and I have ASA 5505 with a basic license. How do I tell that outside a.b.c.100 shall be directed to x.x.x.10 inside? (if that is what I want of course) 

I see in my history that I had a similar problems a while back, unfortunately I had to nuke the setup and so I am sort of start of from the start again.I have two servers set up in DMZ, one FTP and one WWWFTP = 192.168.2.101WWW = 192.168.2.100Outside...

Dear all,About two years ago I (finally) had vpn set up, but I had to nuke the setup a while back (to long ago to remember why).My setup:Cisco ASA-5505 on-board accelerator (revision 0x0)Base license.Cisco Adaptive Security Appliance Software Version...