I need to post an issue i have, but mollom does not allow me to. So I add a txt, this is the only way i've found.
Here the config in a txt
Thanks anyway!
No, I can't. As you can see, half of ports of supervisors are in inactive state.
Gi2/40 notconnect 1 auto auto 10/100/1000-TXGi2/41 notconnect 1 auto auto 10/100/1000-TXGi2/42 ...
Only allowed to power the module:
MAT_SW1_PT2(config)#hw-module slot 4 ? power Enable power to module in specified slot
MAT_SW1_PT2(config)#hw-module slot 3 ? power Enable power to module in specified slot
MAT_SW1_PT2(config)#hw-module slot 2?<1-7>
...
Let's see if I can post now...I'm putting back in production a Cisco 4507R-E switch with two supervisors, and what I need si to enable all SFP ports of 1Gbit by giving up the four ten gigabit ports, which I don't need anymore for the new purpose.I've...