Hi, I have a 3725 Cisco router connected via 2 FastEthernet interfaces to 2 Gigagbit interfaces on a 3750 switch stack. The 3725 is running c3725-advipservicesk9-mz.124-12.bin and the switch is running c3750-ipservicesk9-mz.122-53.SE1.bin, we are seeing incrementing input errors only ( no other errors ) on the 3725 router on both the FE interfaces and incrementing output drops on one of the Gigabitethernet interface on the 3750 switch stack. Steps taken so far: Hard coded both sides to full and speed 100 Checked the replaced the cabling between the switch and router Checked the hardware on the switch , the asic is not dropping any packets Put a hold queue 2000 out on the switch stack gigabit ethernet interface to buffer packets but that does not help, still getting output drops It is highly unlikely that both FE interfaces on the 3725 router are bad at the same time. Any suggestions would be appreciated at this time. Thanks ... View more

Hi , One of my customers wants to set up a IPSec tunnel back to a Cisco Gateway outside the US, due to govt regulations they want an encryption less than 56bits. I wanted to ask  if any body knows a Cisco router that supports 40bit Encryption? Thanks Raj ... View more