This affects all users and APs (only setting up one AP to test for now)I imported 2008 R2 NPS settin...

I've turned debugging on the AP and while I suspect it's something wrong with the 2008R2 box, I was ...

The tunnel is up and functional; I can hit 192.168.200.1 from the 172.16.4.0 subnetHowever, if I try...

Sure (Local LAN is 192.168.200.0, remote LAN is 172.16.4.0. Both /24) protected vrf: (none) local id...

Hello,I have a IPSEC VPN tunnel between my Cisco 891 and a SonicwallCommunication between sites work...

Hey RichardI found part of the problem. route-map ISP2_MAP permit 10match ip address ATT_NATset ip n...

Interestingly, the 172.20.0.0 network works fine. (The one ACL is for a point to point connection no...

The below unfortunately breaks internet access for LAN clients, which is restored if I set ICN_MAP a...

Thanks for replying.I have since created a 2nd set of route-maps for the nat overload statements; no...

I'm having issues trying to do dual NAT with PBR and was hoping for some insight. Our network has a ...

Hello,Thanks for the response!I left the stub on the hub while troubleshooting, it has since been re...

These tunnels work, but EIGRP will sometimes not update the route. Does anyone have any insight into...

Hello All,I am trying to build a DMVPN solution for two sites each with secondary ISPs. The solution...

Hello,Hoping someone might be able to help me here.I have two 7920 phones I'd like to hook up to an ...

Is it possible to use Cisco 7920 wireless phones with a UC520?I have a SCCP file for this phone, but...