About kfischbach

kfischbach · 01-25-2013

We are planning to implement the following policy map for egress traffic on an Nexus 7000:policy-map type queuing dd-1p3q1t-8e-out-10G class type queuing 1p3q1t-8e-out-pq1 priority level 1 shape percent 10 class type queuing 1p3q1t-8...

kfischbach · 01-23-2013

Hallo,the normal behavior of the Nexus 7K is, that QOS is enabled by default and all port are trusted for dscp and cos. We have some connected devices which are conneted through trunks. How can i set this port to an untrust port so that cos values >0...

kfischbach · 01-12-2008

Hallo,we are planning a scaling DMVPN network for around 2000 spokes. Is it possible to install the HUB's behind a Load Balancer so that they are reachable only through 1 VIP address and ALSO the possibility of a direkt spoke-spoke communication when...

kfischbach · 03-23-2006

Hi,we've to build many vrf's and have to run OSPF on each of these.My question is, how many OSPF Processes does a Cat6500 w/ Sup720 can support?regardskf

kfischbach · 02-09-2005

Hi,is it possible to use SLB with a C7513 and when yes, with which IOS-Release and Feature set?regardsKalle

kfischbach · 01-24-2013

Thanks for the answers. I wondering that the nexus is by default rewriting the cos based on the dscp when the packets are bridged from on trunk to an other trunk. See also https://supportforums.cisco.com/thread/2071250"The CoS value is derived bas...

kfischbach · 01-15-2008

Hallo,we've successfuly tested this feature. The trick is only additional GRE-Tunnels between the HUBs with the same NHRP ID. I'll attache a newer design guide and also my HUB configs from our lab. When you need additional infos pleas contact me.reg...

kfischbach · 01-14-2008

Have found the solution. The Hubs must be connected through an separate tunnel on which NHRP runs.

kfischbach · 12-29-2002

Thanks for your answer.My last question, can i use the internal BRI for leased line (two separat B-channels)? And can i use then an separat WIC as an dialer interface?I ask this because i saw a configuration like this except an separat WICas dialer i...

kfischbach · 12-20-2002

Hallo,i think there are some missunderstandings because i am talking about leased lines (not dialer) with the WIC-LL modul.The WIC-LL Modul is then BRI 1 and cann only handle leased-lines.The question again is:When i get an D64S2 or D64S02 (Two separ...

Member Since	‎06-24-2002 11:07 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	24

User Statistics

User Activity

Nexus 7000: "service-policy type queuing output" on port-channel and/or physical port

Nexus 7000: QOS question how a port can be set to untrust

DMVPN: HUB's behind a LoadBalancer and Spoke-Spoke communication

How many OSPF Processes does a Cat6500 w/ Sup720 support?

IOS-SLB for C7500

Nexus 7000: QOS question how a port can be set to untrust

Re: DMVPN: HUB's behind a LoadBalancer and Spoke-Spoke communica

Re: DMVPN: HUB's behind a LoadBalancer and Spoke-Spoke communica

Re: Two separate B-Channels w/WIC-1B-S/T-LL in an C1603

Re: Two separate B-Channels w/WIC-1B-S/T-LL in an C1603