when I run the command " show ip route " right before it shows my routes there is a line that reads:10.0.0.0/8 is variably subnetted, 8 subnets, 2 masks can anyone explain what this means to me ?
i would like to setup a L2 VLAN trunk connection over a VPN. I hear this can be done with a GRE tunnel. I currently have Cisco MWR2941's that i would like to configure the TRUNKs on then push them over a 5520 VPN ( IPSEC Tunnel ) to a 5510. on the ot...
i ran the debug crypto isakmp command and here is the printout.Feb 09 13:26:07 [IKEv1]: IP = 140.32.132.73, IKE_DECODE SENDING Message (msgid=17dab024) with payloads : HDR + HASH (8) + NOTIFY (11) + NONE (0) total length : 84Feb 09 13:26:17 [IKEv1]: ...
I have a ASA 5520 on my local side and a 5510 on the remote end of my connection. on the backside of these I have MWR 2941's. On each 2941 I have a 172.22.117.0/26 VLAN. How can I push this link over my IPSEC L2L tunnel? What would my access lists lo...
after rattling my brain I opened a TAC with Cisco. The problem happened to be a known bug with the version of software I was running. Uploaded the new software and the problem was solved. thank you all for your responses in this matter.
i created a GRE tunnel on both of the 2941's and used the source and destination as the 10.10.10 and 10.10.50 addresses that are already passing through the tunnel. this worked but i can only reach the 172.22.117 network from the remote side when i s...
I have printed the show runs for each router and also a visio that shows what i am trying to do. essentially i need to plug the peice of equipment on my far end that has a ip of 172.22.117.27 into the 2941 ( or asa ) vlan of 172.22.117 and have it be...
Federico,Thank you for this response. I will begin to build this in the translations. For this to work do i need a interface on the routers with the 10.2.2.0 and 10.1.1.0 ? or do i just need to build this ACL in the ASA's?
