Hi,I have an issue problem on one PE (PE-3), if I doing test from the neighbor or another PE to PE-3 using "ping mpls pseudowire <loopback PE-3> <VCID>"  and ping using vrf to PE-3 there is many packet loss, but ping test to loopback PE-3 is normal n...

Hi,Anyone know the cause of the problem below ? This log appeared after ospf establish.%OCE-SP-3-UNEXPECTED_SW_OBJ_TYPE: SW_OBJ handle/type mismatch; expecting oce type label, found 1Thanks,Gilang.

Hi,We have a case MPLS 6PE configuration as below, we can't ping inter vrf in local router from the gateway, but i can ping & browsing from my PC/router behind PE using gateway vrf Test-IPv6, any solution regarding this issue ? Has anyone ever encoun...

Hello,I have a Problem with one PE using Cisco 7206VXR (NPE-G2), The PE only reboot automatically, The following log in PE during and after reboot, Whatwhat causes this problem occurs ? We already replace device the PE using the same type of router b...

Hi,if anyone has ever had the experience VRF Upgrade from ip vrf <vrf name>to vrf definition <vrf name> using command vrf upgrade-cli multi-af-mode non-common-policies vrf ? if I want to use these commands, whether there is downtime for the vrf ?Than...