I have a primarily Cisco network (300+ switches at this time) with a dozen or so HP Procurve devices at the edge. I use VTP to propagate vlans created on my 6509 core router throughout the network to the edge. I have one HP Procurve switch set up w...
We did wireless coverage testing using some 1142 units in autonomous mode, and got a satisfactory result, but upon converting these test units to Lightweight and adding them to our WLC5508 controller, the coverage has decreased noticably. Does anyon...
I have a Site to Site VPN link up between two ASA (8.4) boxes, one of which is on a static IP (on campus) and the other a dynamic IP (remote). The link is up and functional and works flawlessly as I need it to, however, on the dynamic end, ther...
I'm trying to set up a site to site VPN link between the ASA5510 that we use exclusively as a VPN endpoint on campus and a D-Link DIR130 VPN Router off campus, at a local business with a dynamically assigned IP. We currently use the ASA for remote a...
That makes sense. I don't know if it's the case in my deployment because you can be standing right above an access point on the next floor up, and it seems like the penetration the signal gets through walls and floors is just atrocious. Like maybe ...
Pardon my ignorance, but isn't that the opposite of what I want to do? I thought I would want to increase cell size, as it feels like there's not enough coverage to create the overlap that one would need to have full coverage of a facility.
Thanks. Didn't mean to doubt you! Its up and waiting again. I'll let it sit to ensure it stays up this time. Would the ping I set up have to be continuous, or would a ping every 30 minutes be sufficient to keep the connection alive?
Are you sure? The DLINK has settings for both IKE Lifetime (28800) and IPSec Lifetime (7200). When I ran those commands the tunnel went down and hasn't come back up.
