About chercom

chercom · 01-10-2008

I am running MLPPP throughout my WAN. Most recently I installed a 3845 and I had to turn MLPPP fragmentation off in order to get the circuits to stop dropping packets. I am have read multiple articles on MLPPP fragementation and still do not unders...

chercom · 01-15-2008

I could not get my MLPP to work with two ds3s. I opened a TAC case on this issue I was told it will not work but later the tac engineer said that he had seen it worked before. I am told that mlppp is really used when you are trying to cut cost by u...

chercom · 01-11-2008

There are 5 t1s in the bundle. All circuits are up and forwarding packets. This installation has been up for 2 weeks. Just recently the site start complaining about degraded performance. I am just trying to understand WHY MLPPP with fragmentation...

chercom · 04-08-2004

This sounds like a duplex problem. On a connection, if one side is full and the other is half, on the full duplex side you will get runts and on the half you will see FCS. Verify that the two ports are 'hard' config at 100 full, clear the interface...

chercom · 04-08-2004

Is this for filtering inbound or outbound traffic? !in bound trafficint s0 ip access-group 101 in !out bound trafficint s0 ip access-group 101 out

Member Since	‎03-30-2004 08:22 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

MLPPP

Re: Multilink DS3s together?

Re: MLPPP

Re: interface errors on trunk port

Re: Access-list Question