Hi Guys/Gals,
I am having trouble understanding the use of ACL' s in SNMP groups and can't seem to find the exact answer.
The thing is we use SNMP groups for custom views and we would like to limit access to trusted sources via an ACL.
Howeve...
Hi Guys, I'm trying to figure out if it is possible for a C891F router to handle PPPoE authentication etc. and passthrough IP to a device which can not handle PPPoE. I however am very confused about the different kind of bridging modes (full-bridge/...
Hi,
I'm trying to set up a GRE tunnel between me and my buddy for learning purposes. We both use a 1921 Router
However I'm not successful in making this work IRL, In GNS3 this was done in a minute.
I can ping the outside interfaces without any ...
Hi Deepak,
That route already was placed in the routing table when I made the tunnel interface.
I've located the issue that was causing this, A static NAT translation for remote access was wrong. it was a translation for all traffic and not j...
Hi Deepak,
I've added a deny to my NAT access lists and added a static route on both routers.
Standard IP access list INSIDENAT 10 permit 192.168.1.0, wildcard bits 0.0.0.255 (491287 matches) 20 permit 192.168.2.0, wildcard bits 0.0.0.255 30 per...
