I am bidding on a job to install wifi in an office. The office is actually a house from the 1960's. During my site survey you can tell that the walls create a ton of interference. Looking at install 2 2802e in the house and was wondering if a ANT2524...
I inherited a WLC on Hyper-V, management in that office wants an isolated guest network. Model No. AIR-CTVM-K9Software Version 8.10.121.0Normally on a physical device I would just take port 3 and plug it into the firewall and done! Looking for ideas...
I have a site that needs a new Layer 3 switch. Its a smaller site 200 desktops & 200 ish wireless devices. There is 2504 WLC, 2x 2960s & 2 2960x switches all interconnect via 1gb fiber. Main layer 3 is C3750V2 Was thinking of buying a C9300 Thought...
I have a remote site that has 2 switch Ether channeled together. Layer 3 Switch 11 WS-C3560V2-48PS 12.2(50)SE5Layer 2 Switch 22 WS-C3550-48-SMI Version 12.2(37)SEEtherChannel Load-Balancing Configuration: src-macPorts 1-4 on both sides are connected ...
I support a machine network over in the Netherlands and they are using Stratix 5700 - Rockwell Automation 1783-BMS10CGN.It comes with the following features:Stratix 5700 Switch, Managed, 8 Fast Ethernet Copper Ports, 2 Gigabit Ethernet Combo Ports, F...
I agree with everything you said, the reason I asked about ANT2524V4C-R was so I could mount the AP in the attic and the antenna on the ceiling for a better look. This solution only fixes the 2nd floor and the coverage like I said is pretty good.1st ...
No I can create the mgt VLANs without issue. Normally what I do is take a port on the WLC connect it directly to the firewall. Then create an interface for the with IP range, etc. Then create a WLAN and assign to the interface. Now with a virtual WLC...
9k's are not going to happen........... So I am either going to go withWS-C3850-48F-L WS-C3650-48PD-SC9300-48P-E with CISCO DIGITAL NETWORK ARCHITECTURE ESSENTIALS thanks
So core sites run 5k, this is not a core site. I was thinking about 3650 but I had asked about 9300 instead. No need for stack trying to keep the cost down on this. thanks
