I have an SG200-50 with Spanning Tree (RTSP) and loop detection enabled, however when I connect two ports together to test they don't shutdown. The switch just goes crazy as expected, but I wanted the port to automatically shutdown. I have the same s...

I have 3 CISCO switches: SG300-10, SG300-28MP and SG200-50. They are all L2 On the SG300-10, I am able to run the command 'errdisable recovery...' commands, but not on the SG300-28MP and the SG200 doesn't have CLI.   Is there any way I can execute th...

Hi, My network diagram is below. I have two locations that I need to link using a gateway to gateway VPN. One side is using a Linksys RV042 and the other is using Cisco RV042 (which are basically the same thing). In the main office we have 3 VLANs se...

Hello,My issue is not any different from all the posted under this subject, but I couldn't find a resolution in all the articles I read. To start my router is the "Cisco RV042" and not the "Linksys RV042" which confusingly have the same model number....