About Javed.Bundhoo_2

Javed.Bundhoo_2 · 10-25-2010

Hi,I reset a 7931 phone to factory default by holding the hash key when the phone boots. I pressed 123456789*0# when the buttons on the side started to blink amber. the phone resets and stays on upgrading. Nofing happens afterwards. i have verified t...

Javed.Bundhoo_2 · 11-11-2013

Hello Ravi,Thanks for the reply.Actually, the local authority is looking for the type approval for the bluetooth module. From cisco website, there is no type approval for the bluetooth module. If the bluetooth module is present, i would need the typ...

Javed.Bundhoo_2 · 11-11-2013

Hello,I would much grateful if you could help me on this.I have bought an EX60 codec. The part is being held at the customs, since they are asking for a type approval for the bluetooth module in the EX60. However, as per above post, there are no blu...

Javed.Bundhoo_2 · 10-26-2010

Hi Dilip Singh,I have deleted the file "term31.default.loads" from the flash in the folder 7931 and TFTP it back again and the upgrading files started to load.Thanks for your help!

Javed.Bundhoo_2 · 04-03-2010

Hi Dave,The problem when i untagged the voice vlan on a particular port, if another network equipment is connected to that port other than an IP phone, it gets an address in the Voice VLAN.My real issue is, why when plugged in the UC it works fine, i...

Javed.Bundhoo_2 · 04-02-2010

Hi,I am having the same problem with a 521 S. i just uploaded my case onto the following link:https://www.myciscocommunity.com/message/42362#42362I don't want to replicate my case on this post also, to avoid spamming. But i would really appreciate a ...

Member Since	‎04-02-2010 01:21 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	11

User Statistics

User Activity

Phone fails to upgrade after reset to factory default

ex90 Bluetooth

ex90 Bluetooth

Re: Phone fails to upgrade after reset to factory default

Re: voice vlan problem

Re: 524G Says Initializing Network