Hello,
I am sure this is a very simple question but I have been unable to achieve it :-(
My customer have several Catalysts and we realised that when one of these devices is powered down or its uplink is unplugged, alert does not appear in "Alarms ...
Hello,
I realise that a strange lifecylce count is shown in our PI 2.2. When we check licences in Administration>LIcenses we see that we have 92 devices registered from 691 possible ones (Picture 1-Licenses.png).
This is strange because we have mult...
Hello,
Aftter having installed successfully Device-Pack-3-PI3.0-25.ubf and Device-Pack-4-PI3.0-15.ubf in my Cisco PI 3.0 I tried to install pi302-16.ubf.
Progress bar stucked at 98% and at the end PI logged me out by timeout. When I logged in again...
Hello,
Our Cisco Prime 3.0 has crashed after installing pi_technology_package-3.0.2-1.0.56. SSH is available but not web.
Here is the story:
1-. Installed OVA
2-. Installed these following patches:
Device-Pack-3-PI3.0-25.ubf
Device-Pack-4-PI3.0-15.u...
Hello,
Our customer asked us to perform an upgrade from Prime 2.2 to Prime 3.0. Procedure seems very easy (http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-0/quickstart/guide/cpi_qsg.html) but my question is about what happens wi...
Hi Martin,
Sorry for not having updated my question. Fortunately we solved this issue.
Have you a fast hello command in the interface configuration?
ip pim query-interval 10 ip pim sparse-mode ip ospf authentication message-digest ip ospf message-...
Hi Martin,
Thank you very much.
Anyway we noticed that the problem is not the polling interval. We powered down the switch, the event appeared in the consol but the email was not received. How can I know if it was sent?
Regards,
David
Hello,
After having opened a TAC case, they confirmed that is a cosmetic bug but with no operational consequences:
https://tools.cisco.com/bugsearch/bug/CSCuw71231/?reffering_site=dumpcr
Regards,
David
.png "Arumugam Muthaiah"){kind=avatar}