I have a WS-C2960X-24PS-L that cannot communicate with a monitoring collector. It's configured to run SNMPv3. I've compared the config to working devices and cannot see an issue. When I enabled term mon I got the following output: Oct 27 13:55:07.731...
I have an SPA303 that was previously working fine with Ring Central then I cancelled service and tried 8x8, but they weren't able to provision it. Now I'm trying with another voip provider and they can't provision it either. We've ruled out the netwo...
I'm setting up a stub area with 2 routers over a switch. I'm having a problem with getting the adjacency through the switch, but I get it if I use a crossover cable.Besides the ports being active on the switch is there any other configuration that ...
I'm trying to setup OSPF routing over Frame Relay and I'm having a problem getting into config-router mode on 2610 router. I'm at global config and I enterR3#router ospf 1 and it accepts it, but stays in config so I'm not able to enter in any network...
I have a 2620XM and the IOS got corrupted so I'm trying to install an image using the tftpdnld command, but I'm only getting an error that the file couldn't be found. I'm not able to ping the router from my laptop so I'm wondering to what interface t...
Thanks so much for your help on this issue. I found the solution! It was the IOS version all along,but I didn't think it was since it displayed OSPF as an option.I had the REMOTE ACCESS SERVER c2600-c-mz.123-26.bin version which doesn't support it so...
I've thought that maybe it's related to the physical interface or the fact that I'm using a point-to-point interface.So I physically removed and reseated the serial interface. I've also tried using another physical interface and finally I've tried se...
I checked the processes and I don't see OSPF running. My other routers don't have any loopback interfaces set, but they can still get into router config mode without an issue.
