About thunderbird815

thunderbird815 · 03-22-2011

Hello Im setting up a test site to site VPN between Cisco ASA 5520 and cisco 800 or any other VPN capable router (i have 2600xm and 2800). im using ASDM to configure the ASA and CLI to configure the router the inviroment is as the following(the route...

thunderbird815 · 03-27-2011

The results is in the attached file"you can see that the request from 192.168.5.10 is being replied from 192.168.6.110 but the request from 192.168.6.110 is not being replied from 192.160.5.10"FYI 192.168.6.110 cant ping 192.168.5.1 which is the ASA ...

thunderbird815 · 03-24-2011

I also did the comand "sysopt connection permit-vpn" to make the IPsec traffic bypass the interface access-lists but same problem again

thunderbird815 · 03-24-2011

Attached also is the log between the two hosts (192.168.6.110 router side ) and ( 192.168.5.10 ASA side ). the ASA is keep tearing down all types of connections as u see in the log (TCP , ICMP,(telnet although its enabled for the IP 192.168.6.110)

thunderbird815 · 03-24-2011

Hi againThe tunnel is up and Attached is the "sh crypto" commands you have asked, as for the NAT sh commands when i execute them the result is empty on both sides "No NAT translation are configured in order to do the exemption"Thank you

thunderbird815 · 03-23-2011

and only a single PC is connected to the inside interfaces from both sides

Member Since	‎03-22-2011 11:58 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	8

User Statistics

User Activity

site-2-site VPN between ASA 5520 and cisco 800 router, traffic problem

Re: site-2-site VPN between ASA 5520 and cisco 800 router, traff

Re: site-2-site VPN between ASA 5520 and cisco 800 router, traff

Re: site-2-site VPN between ASA 5520 and cisco 800 router, traff

Re: site-2-site VPN between ASA 5520 and cisco 800 router, traff

Re: site-2-site VPN between ASA 5520 and cisco 800 router, traff