Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks,Current setup:1. CM_A trunks with CM_B using non-gatekeeper controlled ICT trunk2. G711 codec used for calls that uses the trunk3. MTP resources selected for trunk's MRGL at both CM4. CSS is correctly configuredProblem1. Phone A(CM_A) dials to ...
Folks, need some heads up as I have exhausted most possible reasons I can find from Cisco.com. Current setup:CCM: CM5.04CUE: AIM module, 2.3.3Task completed so far1. AXL web service activated2. CTI RP for VM & AA added3. 6 CTI ports added4. From CUE,...
Folks,I have a IPCCX 4.0.3 deployed, and recently - we have upgraded it to a HA deployment. Now, the problem is that the cluster reports Partial Service as the VOIP Monitor Subsystem is in Partial Service. Any advise on how I should go about this?Sec...
Is it possible for re-route calls from PSTN to a location within the on-net network? For eg:1. Calls come in from PSTN2. CM answers the call & issues a dialtone3. Calling party presses the extension number within the on-net network of the CM cluster/...
Hi,Would like to find out if I have missed out anything in setting up VT Advantage across multi sites using CCM non gatekeeper controlled trunk. 1.On all sites, region, audio & video bandwidth is set the same. 2. VTA works without any problems on LAN...
Did u create EM Service in the Phone Services?Check out the following link for a step by step guide..http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a008037e638.html
From what I understand, the connection plar-opx command cannot have a wildcard inserted, right? If that is the case, we can only reach one number only with connection plar-opx?
