About kiran

kiran · 03-20-2018

Hi, I am facing some weird issue. when I use 1572IC DC power to the AP's it works fine till 100ft if the power cable runs over 100 feet AP starts rebooting every 15mins or so does any one faced such issue ? any specific restrictions related to pow...

kiran · 03-09-2018

Hi, as per 2700 datasheet we should use Cisco AP2700 power injectors (AIR-PWRINJ4=) it is EOL by Cisco now, could anyone of you please help me to find an alternate power injectors for 2702i AP's Thanks

kiran · 11-28-2012

Hi,I am currently using below IOS versionCisco IOS Software, s2t54 Software (s2t54-IPSERVICESK9-M), Version 15.0(1)SY1, RELEASE SOFTWARE (fc4)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2012 by Cisco Systems, Inc.Compiled Th...

kiran · 10-05-2012

Hi..I have upgraded my 3750X switch from c3750e-universalk9-mz.122-53.SE3c3750e-universalk9-mz.122-55.SE5.binlater that by mistake i typed delete /force /recursive flash:now, I am unable to load new IOSerror loading "flash:c3750e-universalk9-mz.122-5...

kiran · 01-18-2011

Hi,I have installed WCS 7.0 now i have installed Navigator on WCS server.Installation is completed.but when I check the status of WCS, it says "healthmonitor running with errors"any one knows what could be the problem and how much will that effect on...

kiran · 03-20-2018

Thats the problem. longer the electrical cable AP doesn't light up and doesn't connect to controller. I have an AP at 120Ft which works fine and another AP at 225 Ft which reboots in 15 mins post connected to controller. anyway to find out Ap is gett...

kiran · 11-28-2012

Thanks for quick response,is it ok to use in Quad Sup, becaz I have QuadSup

kiran · 10-05-2012

Hi Aru,I did followed all stpes but I forgot to mention boot system flash:before reboot I checked show flash, it was empty... no files were stored in flash as I typed below commanddelete /force /recursive flash enter now switch in ROMMON mode, error...

kiran · 01-17-2011

thanks for your reply,I have tried with ftp aswell. but still the same.any perticular step am I missing ? becaz i see the below error, it says chmod: cannot access `*.sh': No such file or directoryVersion information of installed applications--------...

kiran · 01-16-2011

Gr8 Joe... you are correct...I just did upgrade of my MSE to 7.x version and now i am able to sync and able to see the clients on the WCS map..Thanks again

Member Since	‎08-02-2010 03:21 AM
Date Last Visited	‎06-12-2018 05:59 PM
Posts	25

User Statistics

User Activity

1572i outdoor Access point DC power requirements

Access Point 2702 Power Injector

6509 E VSS IOS

3750 switch IOS upgrade failed

WCS and Navigator

Re: 1572i outdoor Access point DC power requirements

6509 E VSS IOS

3750 switch IOS upgrade failed

Re: ACS 5.0 upgrade not working

Re: WCS and MSE Integration