Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just purchased 3 2960S-48FPD-L switches. I also ordered one (soon to be 2) 3850-24t-L. I am currently looking at purchasing an NM 4-1G module to go with the 3850. My intent in this is to configure etherchannels from the 3- 2960's front SFP ports, t...
I have an issue with a Cisco 871. I have a dsl modem in Bridging mode connect to provide connectivity thru the WAN port to the 871, and then have a VPN tunnel back to my network. When the provider internet goes down, and comes back up, the public sid...
Ok so I have configured my SGE2010P 48 port switch and have everything working except the 1 phone that is plugged into it. I have 3 of these in which are already setup and working properly to include phones, they were configured before I started work...
Thank you for the advice, I enabled the following. !ip sla 1 icmp-echo 173.194.33.116 frequency 30ip sla schedule 1 life forever start-time now!Please advise any needed changes.
I have a monitoring tool that pings every 60 seconds. The issue is the router is located in a remote location that is 45 minutes away. Two trips this week and 4 this month alone, not very efficient.
Well, the other phones that we have plugged into these switched work properly, so I don't beleive that to be an issue. Also to add, port fast isn't enabled on them either. To give you a little more detailed description. The three others I have are s...
