I've tried to remove native from encapsulation command and interface F0/2 on the switch is set up as a trunk (dot1Q). No success. I will try to remove vlan files from flash on the switch and the router later on today and create vlans again, maybe thats some sort of a glitch. I dont see any other reasons for it not to work.
... View more
I have a problem with my 2610 router. I have 2950 switch connected to the 2610 router using trunk connection. On the 2610 router when i assigned IP addres 192.168.0.1 to the interface e0/0 i am able to ping 192.168.0.2 - my Vlan1 interface on the Switch. Then i deleted ip address from e0/0 interface on the router and assigned it to the subinterface e0/0.1 and immediatly i am unable to ping the e0/0.1. subinterface... but here is what i can see throuth the cdp neighbours command: DR_Switch(config)#do show cdp neigh Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone Device ID Local Intrfce Holdtme Capability Platform Port ID DR_Router.dr.com Fas 0/2 136 R 2610 Eth 0/0.1 DR_Switch#show cdp entry * ------------------------- Device ID: DR_Router.dr.com Entry address(es): IP address: 192.168.0.1 Platform: cisco 2610, Capabilities: Router Interface: FastEthernet0/2, Port ID (outgoing port): Ethernet0/0.1 Holdtime : 139 sec Version : Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-JSX-M), Version 12.2(26c), RELEASE SOFTWARE (fc1) Copyright (c) 1986-2007 by cisco Systems, Inc. Compiled Mon 30-Jul-07 18:03 by ccai advertisement version: 2 Duplex: half Management address(es): DR_Switch# This is configuration of the interfaces... (2610 router) interface Ethernet0/0.1 encapsulation dot1Q 1 native ip address 192.168.0.1 255.255.255.0 (2950 switch) interface Vlan1 ip address 192.168.0.2 255.255.255.0 no ip route-cache ________________________________________________ Here is what i did to troubleshoot connection: DR_Router#conf t Enter configuration commands, one per line. End with CNTL/Z. DR_Router(config)#in e0/0 DR_Router(config-if)#ip address 192.168.0.1 255.255.255.0 DR_Router#ping 192.168.0.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.0.2, timeout is 2 seconds: .!!!! DR_Router#conf t Enter configuration commands, one per line. End with CNTL/Z. DR_Router(config)#in e0/0 DR_Router(config-if)#no ip address DR_Router(config)#int e0/0.1 DR_Router(config-subif)#encapsulation dot1Q 1 native DR_Router(config-subif)#ip address 192.168.0.1 255.255.255.0 DR_Router#ping 192.168.0.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.0.10, timeout is 2 seconds: .... No result.... CAn you help me with this problem?
... View more