About Andrew Duffield

Andrew Duffield · 10-28-2015

Hi I have a Cisco 881 running IOS 15.3 I have a Cisco ASA 5512 running ASA 9.1 When I configure the Cisco 881 to connect to the ASA, I get the following message: "No peer struct to get peer description" When I turn off and turn back on the crypto...

Andrew Duffield · 10-25-2015

Hi all, I am trying to create an IPsec VPN tunnel from a Cisco ASA 5512 to a Cisco 881. The local network of the ASA is 192.168.115.0/24The WAN of the ASA is 220.244.7.134 The remote network of the Cisco 881 is 192.168.118.0/24The WAN of the Cisco is...

Andrew Duffield · 10-28-2014

Hi, I have 2 x Cisco 887 routers both using ADSL2+. I want to send all traffic through one router apart from RDP traffic which I want to route through the second router (see attached jpg) I want the first router to be the Default Gateway for all the ...

Andrew Duffield · 08-06-2014

HiI have configured my Cisco 887VAMW with ADSL and Wifi but the only way I can configure the ap and router separately is to be connected to the router by ssh and the ap via console cable.When at the ap# prompt, how do I get back to the router#?I have...

Andrew Duffield · 08-05-2014

Hi,I am trying to configure the ap on a Cisco 887VAMW router but cannot get the Dot11Radio 0 interface to come up, it is stuck on 'reset'Here is my config:ap(config)#do sh runBuilding configuration...Current configuration : 2964 bytes!version 12.4no ...

Andrew Duffield · 10-28-2015

Thanks Jon, I have set the debug commands but I only get the messages mentioned in my post unfortunately. Thanks Andy

Andrew Duffield · 10-26-2015

Hi,Thanks for your reply.I have changed the MTU but this didn't help, it only made my connection drop out.Thanks anyway

Andrew Duffield · 11-02-2014

Thanks Aref, you are a great help. Just regarding the connection from the gateway router to the RDP router, would I just create VLAN1 (172.21.21.253) on the RDP router, plug a cable from eth1 on the Gateway router to eth0 on the gateway router?Would ...

Andrew Duffield · 10-29-2014

Hi Aref, Thanks so much for this. Regarding the second router on 172.21.21.253, how would I best connect that to the gateway router? Would I directly attach from Cisco to Cisco, or connect it to the switch on its VLAN1 interface. Also, would I need t...

Andrew Duffield · 12-04-2012

Hi AlainI have an internal LAN of 192.168.254.x/24.This has a 2008R2 server running DHCP.They have 4 Wireless Access Points.I want to create a separate VLAN for a guest wifi.I want it on the 192.168.253.x/24 subnet.The guest WAP will issue DHCP with ...

Member Since	‎09-29-2010 01:01 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	20

User Statistics

User Activity

No peer struct to get peer description

ASA 5512 to Cisco 881 IPSec VPN - wont connect

Route RDP traffic through separate router

Switching between ap# and router#

%DOT11-4-NO_SSID: No SSID configured. Dot11Radio0 not started

Thanks Jon,

Hi,Thanks for your reply.I

Thanks Aref, you are a great

Hi Aref, Thanks so much for

Configure VLAN on Cisco 881