Hello,
I have a cable modem which is connected with its single utp port to my cisco router on the WAN1 port, then i have connected the router to my managed cisco switch.
Now my tv digicorder needs a utp connection directly to the cable modem but as i...
Firmwarev4.2.3.07 (Oct 8 2015 15:29:55
I have created a new service with TCP port 8007 to 80 in the service management under UPnp section.
I already have three rules active there.
But if I create the rule then with the IP address linked to it and en...
Can you tell me which model of SBS router with the same features as this RV042G is the big brother? Just because I need a bigger dhcp range then 50, more forwarding rules, more firewall rules, etc.
Can somebody explain me why I see another dat in the firmware :Firmware Version : v4.2.1.02 (Jan 18 2012 14:10:55)and in the firmware download page they speak about 08 june 2012 for this same version number??
Today the power was fallen out in our area and the rv042g was turned off.After the power was back I was checking the router because some trafic didn't came through.Then I saw that all the services were messed up and also all the firewall rules were w...
Hello,
I have not solved this and I hope Cisco will do something about it.
It looks like they just leave it as it is.
Why should I need to call them, I described my problem, they can test themselves and look for a solution.
Why don't they create the...
Hello,
See my answers below:
>>Please confirm how your router RV042G WAN ports gets configured (static/DHCP or PPOE connection)?
The WAN port gets a public IP address from my ISP provider.
WAN1Obtain an IP automatically
>>Also confirm, what type of ...
Hello Kenny,
thank you very much for this information.
I will try this out and I hope Cisco will open a ticket to solve this in their GUI webinterface.
I'll let you know if it helps.
Best regards,
Ryan
