i have configured the firewall to lease dhcp ip, created vlan, qos. The configuration done on the switch are only   Switch(config)# int gi6 Switch(config-if)#switchport mode access Switch(config-if)#switchport access vlan 10   But still the Gi6 port ...

This is a simple qos configuration. I want remark it using the dscp command (ie: where to specify set ip dhcp command and match ip dscp command) . The intention here is to limit the bandwidth using shape command and if it exceeds then must be dropped...

isp has 200 mbps i need to limit it to 30 mbps(1:1)  on each ports of the sg300 switch.

I have a 3925 cisco router which is connected to SG 350 Semi manageable switch. I have an isp with 200 Mbps connection. I want port 3 of switch to get 20 Mbps only. Port 3 is in vlan 20. I have done till this onlyRouterint gig0/0ip address 192.168.52...

Here in the diagram below i should be able to do all communication from PC1 to the webserver using only NAT/PAT Concepts, but without using any of the routing protocols.