About gb-fairchild

gb-fairchild · 11-11-2012

Jabber 9.1CUCM 7.1.3Windows 7 32 bitCisco Presence 8.0.2.10000-30 Jabber for windows - periodically tries to re-install and fails. After install Jabber works for awhile but then when trying to open another program(Outlook, IE Explorer) it tri...

gb-fairchild · 10-05-2012

We are replacing a Mitel PBX at one of our sites with call manager and a 2951 router as an MGCP gateway. They have seperate paging amps and Bogen TAM-B units for upstairs and downstairs paging. I have paging working using FXO ports configured for l...

gb-fairchild · 06-28-2012

We have call Manager 7.1.3, MGCP gateway on Cisco 2811 running IOS Version 12.4(25b), with SRST configuredMy question: If a user at the remote site is on an external call to the PSTN and the gateway looses its connection to Call Manager the gateway...

gb-fairchild · 02-06-2012

Multilink PPP questionI have a Cisco 2811 with 8 serial interfaces. Three of them are in multilink1 which is our active connection to AT&T MPLS. I have the other 5 in multilink3 which will be an upgrade to a new MPLS. The two multilinks have diffe...

gb-fairchild · 05-25-2011

Has anyone tried the Fidelus Console (operator attendant console)? When I upgrade to CUCM 8.x I'm going to need an attendant console. I think the ARC one that Cisco is pushing which requires a seperate server is overkill for what we need. I would ...

gb-fairchild · 01-11-2013

Did you ever figure this out?? I have one remote site that reports periodic drops. TAC has not been able to find anything.CUCM 7.1.3GWay is 2951 running C2951 Software (C2951-UNIVERSALK9-M), Version 15.1(4)M4, RELEASE SOFTWARE (fc1)

gb-fairchild · 11-12-2012

I did as you suggested - quit Jabber, opened a one-click from Outlook and then tried to start Jabber again. I got the same error as noted above. Is there a work-around for this?Thanks,Bill

gb-fairchild · 02-09-2012

Here is the solution(from Cisco TAC): There are two mutlilink's on this router. Both were using the local endpoint discriminator of Ply2811MPLS. This caused a problem when trying to add an interface to the new multilink(multilink3). We added a...

gb-fairchild · 02-06-2012

Thanks for looking at this. I changed the mtu size as you suggested. Still no luck. It looks ok until this message:Feb 7 02:07:32.307: Se0/2/0:0 MLP: cdp packet forwarded to wrong interfaceThen it goes ahead and drops the link from the bundle and ...

gb-fairchild · 11-23-2011

Thanks for the feedback - we have not upgraded to cucm 8 yet so this is helpful. What version of cucm did you test with?Thanks,Bill

Member Since	‎04-18-2008 12:42 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	74
Total Helpful Votes Received	10

User Statistics

User Activity

Jabber for Windows - periodically tries to re-install and fails

Send audio to 2 fxo ports at the same time

Call survivability with MGCP Gateway

ppp multilink problem

Fidelus Console

Dropped calls with CUCM 6.x

Jabber for Windows - periodically tries to re-install and fails

Re: ppp multilink problem

Re: ppp multilink problem

Fidelus Console