About bkepford1

bkepford1 · ‎12-17-2013

Also Q4 States that Cisco VXR 7200 is a supported CUBE Platform but Q20 has no reference for sizing on that platform.

bkepford1 · ‎12-17-2013

Lavanya, Is there a reference to how many DSPs are needed for same codec SIP tunks on a CUBE router? Say if I had 100 concurrent SIP calls all running G711 how many DSPs would that require. Thanks B

bkepford1 · ‎08-03-2012

After the registration process goes through which it eventually does it receives a certificate and then authenticated with EAP-TLS and I don't get the message. The MAC shown is the policy services node.

bkepford1 · ‎08-01-2012

I am running ISE 1.1.1 and have gone through the design guide and setup the certificate based wireless authentication and device registration process using the ISE as a SCEP proxy for handing out certificates. On the device registration portal instead of showing the device MAC the policy services node MAC shows up and I get an error that says "We are unable to determine access privileges in order to access the network. Please contact your adiminstrator." The an hour later I can connect just fine. The authentication logs on ISE are exactly the same in both cases. So it seems like a bug I opened a TAC case but am also posting here.

Date Registered	‎08-14-2008 10:47 AM
Date Last Visited	‎05-22-2019 12:07 AM
Total Messages Posted	2

Re: Frequently Asked Questions: Cisco U...

Re: Frequently Asked Questions: Cisco U...

ISE BYOD Error: "We are unable to deter...

ISE BYOD Error: "We are unable to deter...