Hi..on IOS versions higher than 12.2(50) on Cisco 3560G-48TS I get this error/traceback, when I reach a certain number of Access-lists group'ed to "interface vlan", and the ACL inserted in the TCAM reaches acl label #128 (can be seen with : Show plat...

Hi.. I seem to have a problem when my access switches are configured with greater than 127 access-lists group'ed to interfaces.The access-list group'ed to an interface with ex:interface vlan 100ip address 10.10.10.0 255.255.255.0ip access-group 2333 ...

Hi,I have a redundant ASA setup using 2 OSPF processors, one for the external core network and one for the internal core network.Normally I have public IP's from the external OSPF being inserted into the routing table on the ASA, and private IP's com...

Hi.I have a network based on (mostly)C3560G switches using L3 and OSPF everywhere except at the access ports where servers are connected. I was planning to use ACLs to restrict packet flow through the router part of the switches. I don't care about t...